|
OPERATING CHARACTERISTICS:
When a SENSING-SAF-START® is installed on any equipment and there
is an electrical power interruption to the equipment, the SENSING-SAF-START®
will open the circuit so when the power source is restored, the SENSING-SAF-START®
will prevent the equipment from restarting. The SENSING-SAF-START®
will not reset until the equipment switch has been turned "off".
There is a sensing circuit within the new SENSING-SAF-START® that
sends a signal up to the equipment switch to see if it is in the "on"
position. If the switch is still "on", the SENSING-SAF-START®
sounds a warning buzz when the reset button is depressed, and it will not
close the circuit until the equipment switch is turned "off".
Then, and only then, the SENSING-SAF-START® will close the circuit,
so the equipment will operate again. |
SENSING-SAF-START® PHYSICAL DESCRIPTIONS
AND RATINGS: |
jds
Model |
Description |
Electrical Ratings |
| 1996 |
Short extension cord style. Fourteen inch cord on male plug end, twelve
inch cord on female receptacle end. |
120-volts, A.C., 15-amp, 50/60 cycle. |
| 1997 |
Twenty inch cord on equipment switch end. Eight foot cord with molded
plug on power end. |
120-volts, A.C., 15-amp, 50/60 cycle. |
| 1998 |
Twenty inch cord on equipment
switch end. Eight foot cord on power end
(no plug). |
120-volts, A.C., 18-amp, 50/60 cycle. |
| 1999 |
Twenty inch cord on equipment switch end. Eight foot cord on power end
(no plug). |
200 to 240-volts, A.C., 15-amp maximum(single phase), 50/60 cycle. |
|
